Not every leak announces itself with a puddle. Many start as a slow drip behind a wall, under a cabinet or below a floor, and the first clue is a higher water bill, a stain or a musty smell. Turrbros Plumbing uses pressure testing, moisture readings and careful inspection to narrow down where water is escaping before opening anything up. Once the source is found, we repair or replace the failed pipe, fitting or valve and check that the system holds pressure. You get a clear explanation of what failed, what was repaired and whether any drywall, flooring or cabinet damage needs attention next.
What is included
- Water meter and pressure checks
- Inspection of supply lines, valves and fittings
- Moisture readings around suspected areas
- Repair or replacement of the failed section
- Pressure test after the repair
- Notes on any water damage to address
Signs you may need this service
- Water bill rising with no change in use
- Sound of running water when fixtures are off
- Stains, bubbling paint or soft drywall
- Warm spots on the floor
- Musty smells or mold near walls or cabinets
How it works
- Check the water meter with all fixtures off
- Narrow down the leak with pressure tests and moisture readings
- Open only the area needed and repair the failed part
- Pressure test and walk you through the repair
Why customers choose Turrbros Plumbing
- 15 years in business
- Insured
- Bonded
- Upfront pricing
- Clear communication
Leak detection and repair: common questions
How do I check for a leak myself?
Turn off every fixture and appliance that uses water, then watch the water meter for several minutes. If the dial or leak indicator moves, water is going somewhere.
Will you need to cut into my wall?
Sometimes, but testing first keeps the opening as small as possible. We explain where and why before any drywall or flooring is opened.
